Tutorial 4 troubles.

A place to discuss everything related to Newton Dynamics.

Moderators: Sascha Willems, walaber

Tutorial 4 troubles.

Postby Amaroker » Sat Nov 15, 2008 7:41 pm

Hello everyone. I just downloaded Newton the other day and I'm experiencing some problems with tutorial #4 (samples/tutorial_04_IntroductionToMaterials). When loading the project in Visual Studio 2005 I was prompted to convert it to the current Visual C++ project format.

The program runs, but I'm having difficulties controlling the ball. It won't move at all (just spinning at the spot), except for the flying mode where it lifts from the ground. Also, after a few seconds the torque call back function will no longer get called (the ball then stops spinning - or If in flying mode, it falls to the ground).

What could be causing this behaviour? Any help is much appreciated.

/ Johan
Amaroker
 
Posts: 1
Joined: Sat Nov 15, 2008 6:41 pm

Re: Tutorial 4 troubles.

Postby Julio Jerez » Sat Nov 15, 2008 10:50 pm

do not bother wit that SDK it is 3 years old.
send me a pm for the newer SDK
Julio Jerez
Moderator
Moderator
 
Posts: 12249
Joined: Sun Sep 14, 2003 2:18 pm
Location: Los Angeles


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 23 guests

cron