A place to discuss everything related to Newton Dynamics.
Moderators: Sascha Willems, walaber
by jay3d » Thu Jul 31, 2008 1:41 pm
Hi,
What is the most accurate mode for the solver?
regardless of the speed
(speed is not that important in content creation tools, but accuracy)
Thanks!
-
jay3d
-
- Posts: 33
- Joined: Sun Jul 13, 2008 11:51 am
by Dave Gravel » Thu Jul 31, 2008 1:50 pm
Just to use 0 on all solver.
The only place where you can need to set higher value and it is not a solver , I talk about the Architecture and 3 is normally a good choice.
I know you say the speed is not really important but all solver set to 0 is more angry with many joint's or many contacts in same time.
If you don't need many contacts in same time the speed stay normal and it don't really cost more.
-
Dave Gravel
-
- Posts: 800
- Joined: Sat Apr 01, 2006 9:31 pm
- Location: Quebec in Canada.
-
Return to General Discussion
Who is online
Users browsing this forum: No registered users and 17 guests